Depending on the protocol used for the current session, there may be
a submenu of \q{special commands}. These are protocol-specific
-tokens, such as a \i{\q{break} signal}, that can be sent down a
+tokens, such as a \q{break} signal, that can be sent down a
connection in addition to normal data. Their precise effect is usually
-up to the server. Currently only Telnet and SSH have special commands.
+up to the server. Currently only Telnet, SSH, and serial connections
+have special commands.
+
+The \q{break} signal can also be invoked from the keyboard with
+\i{Ctrl-Break}.
The following \I{Telnet special commands}special commands are
available in Telnet:
POSIX signals. Not honoured by all servers.
}
+With a serial connection, the only available special command is
+\I{Break, serial special command}\q{Break}.
+
\S2{using-newsession} Starting new sessions
PuTTY's system menu provides some shortcut ways to start new
does do.
You should then tick the \q{Enable X11 forwarding} box in the
-Tunnels panel (see \k{config-ssh-x11}) before starting your SSH
+X11 panel (see \k{config-ssh-x11}) before starting your SSH
session. The \i{\q{X display location}} box is blank by default, which
means that PuTTY will try to use a sensible default such as \c{:0},
which is the usual display location where your X server will be
For information on X11 forwarding, see \k{using-x-forwarding}.
These options are equivalent to the X11 forwarding checkbox in the
-Tunnels panel of the PuTTY configuration box (see
-\k{config-ssh-x11}).
+X11 panel of the PuTTY configuration box (see \k{config-ssh-x11}).
These options are not available in the file transfer tools PSCP and
PSFTP.